How to check the plastic shredder equipment

The plastic shredder equipment blade is an important part of the equipment. If it is worn or blunt, it should be repaired or replaced in time. It should be repaired in time, and the inspection and maintenance of the blade should be done in peacetime. The plastic shredder equipment has a unique hydraulic slide design, which is safer and more convenient for operation.

The inspection of plastic shredders is also more stringent:

1, the multi-point dry oil pump and its pipeline supply.

2, whether the wedge adjustment block adjusts the position to meet the design technical requirements.

3, observe whether there are places that touch each other, and everything can be turned on after normal operation.

4, confirm the direction of rotation, what is the test run motor alone no-load operation for 2h, check the bearing temperature.

5. Keep the flywheel away from the dead point so that it can overcome its inertia when starting.

Sixth, install the V-belt, adjust the degree of tension and the parallelism between the two wheels.

7. Before the plastic shredder is started, the dry oil pump must be started first to refuel the lubrication points.

8. The no-load test run is 4h. If the shredder is in operation, it should meet the following requirements:

9. There should be no abnormal sound between the bracket and the bracket.

10. There should be no loud noise between the locking spring and the tie rod.

11. The bearing temperature rise shall not exceed 30 °C. There must be no abnormal fluctuations.